Nintendo GameCube Mono Hookup

Nintendo GameCube RF to TV Hookup


- Locate the TV's VHF IN [ANT, CATV, VHF Screws] or Cable Connector.
- Remove existing cable wire from TV's VHF IN.
- Connect the Short Thick Wire of the RF Switch (labeled TV) to the VHF IN.
- Connect Existing Cable Line [previously removed] to the silver post [Cable Connector] on the RF switch (labeled ANT).
- Plug the RF Modulator into the Analog AV Out port on the back of the GCN.
- Connect the Thin Wire of the RF Switch (labeled Control Deck) to the RF Modulator (labeled RF Out).
- Set the 3/4 switch of the RF Modulator to match the 3/4 channel setting used on the TV.
Note: The RF Modulator does not produce stereo sound. To get stereo sound, connect your Control Deck to your TV or VCR using the Stereo Audio/Video Cable.
- Make sure the system is on a hard flat surface. Allow plenty of space around the unit for ventilation. Make sure the power button is in the OFF position (button is not pressed-in).
- Plug the AC Adapter into the back of the system into the DC 12V In port (fits only one way). Plug the other end into a wall outlet.
- Hook up the controller(s), starting from the far-left port on the front of the GCN.
- Press the Open button to open the Disc Cover. Insert a Game Disc, printed side up, into the compartment and on the center hub. Press down gently on the Game Disc until it locks on the center hub.
- Close the Disc Cover.
- Turn the power to the TV on and set TV to the appropriate channel (3 or 4).
- Press the Power button on the Nintendo GameCube and check that the power light comes on. The Nintendo GameCube logo should appear on the screen, followed by the main menu.